This object is in archive!
How to power down zipabox with Backup Module connected
Need Answer
In order to connect the security module, it says that i must power down
the zipabox. How is this done properly once you have the battery backup
module already connected? Is there a shutdown command somewhere, or do you
have to disconnect the backup module just to install the security
module?
The same question Access denied
You can't vote. Please authorize!
You can't vote. Please authorize!
No connection
Real-time notifications may not work
Yes, just disconnect the backup power module. I have done it a hundred times without a problem. Before or after power is disconnected has not been an issue yet. But I'd say before prefereably.
Yes, just disconnect the backup power module. I have done it a hundred times without a problem. Before or after power is disconnected has not been an issue yet. But I'd say before prefereably.
Hi,
very good question. I think you just have to disconnect the Bacupmodule.
regards Helle
Hi,
very good question. I think you just have to disconnect the Bacupmodule.
regards Helle
Thanks for the quick reply. I'm thinking just to be sure, i will let the backup module battery just run dry, and then let it recharge once i have my alarm system wired in and connected.
Thanks for the quick reply. I'm thinking just to be sure, i will let the backup module battery just run dry, and then let it recharge once i have my alarm system wired in and connected.
Yes, just disconnect the backup power module. I have done it a hundred times without a problem. Before or after power is disconnected has not been an issue yet. But I'd say before prefereably.
Yes, just disconnect the backup power module. I have done it a hundred times without a problem. Before or after power is disconnected has not been an issue yet. But I'd say before prefereably.
Replies have been locked on this page!