This object is in archive!
Aeon Labs Recessed Door Sensor (GEN5)
Under Consideration
I can add one! Works perfect but cannot add anymore after? is this known?
I like this idea 
No connection
Real-time notifications may not work
I just purchased several of these and had a very hard time adding them. What I found worked reasonably reliably was to do the following steps:
1) Do a Factory Reset of the sensor by pressing the button for 20 seconds.
2) Reboot the ZipaBox
3) Ensure I keep the sensor within a couple of inches from the ZipaBox
4) Start the add device process (which begins a sensor reset)
5) Press the sensor's button
6) The inclusion process begins
7) Press the sensor's buton
8) Continuously wave the sensor across the close-door magnet to ensure sensor does not go to sleep
I just purchased several of these and had a very hard time adding them. What I found worked reasonably reliably was to do the following steps:
1) Do a Factory Reset of the sensor by pressing the button for 20 seconds.
2) Reboot the ZipaBox
3) Ensure I keep the sensor within a couple of inches from the ZipaBox
4) Start the add device process (which begins a sensor reset)
5) Press the sensor's button
6) The inclusion process begins
7) Press the sensor's buton
8) Continuously wave the sensor across the close-door magnet to ensure sensor does not go to sleep
Replies have been locked on this page!