After firmware update to 0.9.999.8 sensors no longer send their status
Solved
I have a serious problem after updating to 0.9.999.8: no sensor or switch sends it status to the box. This results in rules not working, but also devices losing connection to the box. Reverting back to the beta firmware does not solve the problem. I created a support ticket, but so far no luck there ... What should I do now? Send back the box? It's pretty much useless now ...
The same problem 
No connection
Real-time notifications may not work
I have exactly the same problem after update to 0.9.999.8.a
No mouvement detection on my 4 SP103
I have exactly the same problem after update to 0.9.999.8.a
No mouvement detection on my 4 SP103
The problem was solved after an update to 0.9.999.8b. I had to re-initialize my devices. For this I changed the type from "light" to "on/off switch". Then I synchronized the rules. With some rules I had to replace the "when" clause with a new one. This was advised by the support team.
The problem was solved after an update to 0.9.999.8b. I had to re-initialize my devices. For this I changed the type from "light" to "on/off switch". Then I synchronized the rules. With some rules I had to replace the "when" clause with a new one. This was advised by the support team.
Solved
delette / exclusion the 4 devices sp103 Motion detection
Add / reallocated 4 devices
reaffect device name on the rules
It's OK but why the update destroy configuration stable since many days .....
Solved
delette / exclusion the 4 devices sp103 Motion detection
Add / reallocated 4 devices
reaffect device name on the rules
It's OK but why the update destroy configuration stable since many days .....
After 1hour IDEM
No mouvement detection on my 4 SP103
After 1hour IDEM
No mouvement detection on my 4 SP103
This problem is solved by Team Support ZIpato
This problem is solved by Team Support ZIpato
Replies have been locked on this page!