Unable to interface a switch on an existing KNX installation

Pierre Crokaert shared this question 9 years ago

I have integrated the Zipabox + RF433 + KNX extension in my KNX installation.

I was easily able to configure other ZWave and Chacon modules on the Zipabox, that part works.

Then I connected the KNX network to the ZipaBox extension, and I was able to configure it with ETS, all downloads are working.

But when I connect a group to a datapoint for action and another for status, I am able to read the status but not write to the output.

If I monitor the bus with KNX, I see that no message is emitted by the Zipabox.

Any idea on what is going wrong?

Leave a Comment
Attach a file