This object is in archive!
Zipabox stops rules and scenes execution
In Progress
Since yesterday all stops, I think after problems with the connection (blinking green LED).
When stable again, tried to restart, 5 sec button 2 + reset, etc. Synchronizing afterwards.
Stil no results until now in getting it working again.
The same problem 
No connection
Real-time notifications may not work
Much in Zipato is undocumented. When I restarted with button -2+ reset, the old firmware 0.9.999.3c was reactivated. Going to the latest version 1.0.17, did not solve the problem; nothing works, NO-scene commands or switches in the browser activates any device, although the GUI says it did.
Late sunday, I searched the community for other experiences. I found: deactivate ALL rules en restart!
Finally it solved (part) of the problem: devices/ switches are working again.
Next step (tomorrow) will be: re-activating the rules, rule by rule, which is time consuming as mentioned.
--> IMHO there should be an Version Manager locally with "last known GOOD configuration", that can be stored locally (not only firmware)!
Much in Zipato is undocumented. When I restarted with button -2+ reset, the old firmware 0.9.999.3c was reactivated. Going to the latest version 1.0.17, did not solve the problem; nothing works, NO-scene commands or switches in the browser activates any device, although the GUI says it did.
Late sunday, I searched the community for other experiences. I found: deactivate ALL rules en restart!
Finally it solved (part) of the problem: devices/ switches are working again.
Next step (tomorrow) will be: re-activating the rules, rule by rule, which is time consuming as mentioned.
--> IMHO there should be an Version Manager locally with "last known GOOD configuration", that can be stored locally (not only firmware)!
Replies have been locked on this page!