Fibaro FGMS-001 no motion

Christophe Bouton shared this idea 21 months ago
Completed

Hi everybody

I have installed my Fibaro on my Zipabox zwave module

I can see it in the admin panel but as you can see, there's "No motion" displayed. And i can't activate it (or i don't know...

And, of course, i don't see any motion detection.

Could you help me ?

Thank you

Chris

fbd05bc2c30b8615408e738dccfc6933

Replies (6)

photo
1

Thank you for your answer Mihael

My device is on battery, it's not possible on main powered

Best regards

Chris

photo
1

Yes i change the battery 3 days ago and re incluse several times 😢 always the same problem

photo
1

The distance is 0,5m :(

How can i wake up the sensor ? just by moving ahead ?

Thanks Patrick

photo
1

Hello,

Can you still retrieve parameter values? Could you please check the parameter for sensitivity and if it is configured properly?

Sometimes those devices need to be triggered a couple of times to finally wake up and start responding.

You may try to do a Z-Wave Reset, reboot the ZipaBox afterwards and then try to add the device.

Also, make sure that your Z-Wave antenna is plugged in properly.

Best regards

photo
1

Hi

I included 3 fibaro FGMS-001 modules in firmware 2.6 on the zipabox 2 and nothing works... Anyone have an idea?

Regards

photo
1

Hi

I included 3 fibaro FGMS-001 modules in firmware 2.6 on the zipabox 2 and nothing works... Anyone have an idea?

Regards

Leave a Comment
 
Attach a file