Zipato - Is it possible to set the report interval ?

Madhushi Perera shared this question 14 months ago
Need Answer

Hello,

I would like to know if there is a configuration to set report interval on Zipato.

On the attached picture, you can see I have a measurement only when the value changes. I would like to have a value every 30 min even it is the same. Is is possible to configure this ?

For information, this device is a MH9-CO2 and I saw it has parameters like :


  • Parameter 2: CO2 report interval. Size: 1 Byte, Default Value: 10 (Valuex5ppm).
  • Parameter 3: Temperature report interval. Size: 1 Byte, Default Value: 1 (Value x 0,5°C).
  • Parameter 4: Humidity report interval. Size: 1 Byte, Default Value: 2 (Value in %)

But if I understand correctly, it still depends on value change.

I also saw that in the config of the device , we find these parameters (configuration) but also other parameters like :

  • wakeUpInterval
  • periodicallyWakeUp
  • minWakeUpInterval
  • wakeUpIntervalStep
  • maxWakeUpInterval
  • defaultWakeUpInterval

Are those parameters more suitable for my need ?


Do you have a solution ?

Thanks in advance.

Replies (2)

photo
1

Very helpful

photo
1

you could use manual configure the parameters..

79c12e8c9df6d871eed1eaf70b75adaf

Replies have been locked on this page!