This object is in archive! 
Danfoss LC-13 thermostat missing
Known
Hi,
I own three Danfoss LC-13 radiator thermostats. Two of them works perfectly under Zipabox, including temperature schedules, but the third unit won't behave like the first two.
It's properly included in the Z-wave network and I can see it in the device browser, but only as temperature meter. No matter how hard I try I can't seem to get it to show up in "Thermostats" with the first two units, so planning temperature schedule is impossible. Please advise how to fix this.
You can't vote. Please authorize!
No connection
Real-time notifications may not work
Hey, make a reset of the Danfoss and then re-include it. That worked for me.
Hey, make a reset of the Danfoss and then re-include it. That worked for me.
Thank you! I had added and removed the valve from the ZB control panel over and over again, but a factory reset of the valve itself was needed. You truly deserve a merry Xmas for sharing the advice!
(To do this: Remove battery from valve, press and hold the o-button 5s while inserting battery, and the valve is fresh again.)
Thank you! I had added and removed the valve from the ZB control panel over and over again, but a factory reset of the valve itself was needed. You truly deserve a merry Xmas for sharing the advice!
(To do this: Remove battery from valve, press and hold the o-button 5s while inserting battery, and the valve is fresh again.)
:-)
:-)
Replies have been locked on this page!