Non of my rules run

Mikkel Aronsen shared this problem ago

Solved

Hi, se attachment for the rule i have created. the rule dont run.

I have a Aeon Multisensor 6 trying to get it to turn on my lights with my fibaro dimmer 2(fgd212).

I have saved and synced.

The motion sensor is triggering event loging in zipato web app so its working but the rule is not executed?

Files:

The same problem 0

Replies (4)

Adrian Van Der Heijden ●

Looks good, why do you have a wait rule at the end?

You did sync on the right hand menu didn't you?

Reply URL

Mikkel Aronsen ●

The wait rule was there to wait and then turn the lights of again but i se that this dont work to have that there i moved it down to top in the else statement.

sync and saved on the right side.

URL

Alberto Macias ●

This is my setup for motion activated light, I use fibaro motion sensor and zipato RGBW bulb. One thing I noticed in your rule, you are using "Action" instead of "Set", try to change and see if it works.

Files:

Reply URL

Mikkel Aronsen ●

Did as you did Alberto Macias se attachment, it worked immediately when i changed it to set and level, thanks

Files:

Reply URL

Attila Hajdu ●

Put a Join between WHEN and IF. This will ensure that the rule will not be executed if the motion sensor changes it state to no motion and motion within a short period (I.E. it will always run at the last trigger and the previous triggers will be ignored).

Reply URL