This object is in archive!
Aeon Labs multisensor - motion/no_motion state
Need Answer
Hello
i have setup my alarm system using zipabox and aeonlabs multisensor.
when i leave the house and arming alarm, the exit sensor is in motion state because it's near the exit.
the arming delay is 120s and the delay between motion and no_motion is 240s
when the sensor get back to no_motion state, the alarm is triggered.
why ?
does the arming delay must be always superior to the sensor state delay ?
Thanks
The same question
No connection
Real-time notifications may not work
No it should work. How is the partion set in armed state? No_motion?
But if you trigger the motion, you can't arm within 240s because it will not be ready. Right?
No it should work. How is the partion set in armed state? No_motion?
But if you trigger the motion, you can't arm within 240s because it will not be ready. Right?
Replies have been locked on this page!