Alarm partition is always not ready
Need Answer
I have two alarm partitions for different purposes. They use partly the same devices (zones).
Partition 1 works fine and can be armed quickly by i.e. virtual switch.
Partition 2 is always not ready (zones are not ready), even they showed up in partition 1 as ready.
Do zones only serve for one partition?
Any help wellcome.
The same question
No connection
Real-time notifications may not work
Does no one have an idea?
Does no one have an idea?
I guess your problem is not clear to me. Can you please post pictures of your zones configuration?
I guess your problem is not clear to me. Can you please post pictures of your zones configuration?
Hello,
yes zones in this case will work only in 1 partition.
Best regards
Hello,
yes zones in this case will work only in 1 partition.
Best regards
If what Mario says is true, then in this case, create 3 zones, the additional zone can be for the common sensors used in the other 2 zones. Use a rule to trigger this zone on and off via the other zones.
Though this may need you to purchase another licence for an additional security zone. :-( If so, then create virtual sensors that rely on the physical sensor to change state (via rules), and use these virtual sensors in the 2nd security zone.
If what Mario says is true, then in this case, create 3 zones, the additional zone can be for the common sensors used in the other 2 zones. Use a rule to trigger this zone on and off via the other zones.
Though this may need you to purchase another licence for an additional security zone. :-( If so, then create virtual sensors that rely on the physical sensor to change state (via rules), and use these virtual sensors in the 2nd security zone.
Replies have been locked on this page!