This object is in archive!
Control outputs separate on Fibaro RGBW
Known
Hi
I use the Fibaro RGBW to control my water heated floor and have been doing that for some time. But after a power failure I had to reset the Fibaro RGBW to be able to connect to it again. My problem now is that I can’t controlled the outputs separate as I did before.
I can’t remember that I needed to change any parameters before, I just added the colors to show as a device, but when I do that now I can not change the value on it.
I see it in my device browser, but can not change the output level.
This is a picture how i had it in my device broswer before reset.
Anyone that can guide me on what I'm doing wrong?
The same problem 
No connection
Real-time notifications may not work
Answer from support that solved the problem!
Hi,
please try upgrading to Beta firmware and then adding the device again. This time do not name it at the end of process, but rename it afterwards.
Please contact us again if the problem persists.
Borna
Answer from support that solved the problem!
Hi,
please try upgrading to Beta firmware and then adding the device again. This time do not name it at the end of process, but rename it afterwards.
Please contact us again if the problem persists.
Borna
I found a old image of the structure in device manager. And it looked very different before I reset the device?
As my image in my question shows that all colors are now under Color control, before they where separate directly under main group.
I found a old image of the structure in device manager. And it looked very different before I reset the device?
As my image in my question shows that all colors are now under Color control, before they where separate directly under main group.
Answer from support that solved the problem!
Hi,
please try upgrading to Beta firmware and then adding the device again. This time do not name it at the end of process, but rename it afterwards.
Please contact us again if the problem persists.
Borna
Answer from support that solved the problem!
Hi,
please try upgrading to Beta firmware and then adding the device again. This time do not name it at the end of process, but rename it afterwards.
Please contact us again if the problem persists.
Borna
Replies have been locked on this page!