This object is in archive!
Exit Zone Problem
Known
I configure my door as Exit-Zone (and Entry Zone). I think many users will do that.
When I have armed my system I open the door and get out. The door get armed too a few seconds later. Thats ok.
But if I open and close the door a few seconds later (within the HOME Exit Delay) for example to get my car keys, the HOME Entry Delay starts from this moment and the alarm tripped when i am sitting in my car ;-(
I thought I could compensate that with a motion detector(as Cross Zone). But it does`t works fine in Exit/Entry Zone.
How did you solve this problem?
The same problem 
No connection
Real-time notifications may not work
https://community.zipato.com/knowledge-base/article/alarm-security-zone-exit-zone-is-used-for
This is how it is supposed to be. If you forget your keys, or whatever, you will have to disarm your alarm. Or remove the Exit Zone and just have the countdown timer.
https://community.zipato.com/knowledge-base/article/alarm-security-zone-exit-zone-is-used-for
This is how it is supposed to be. If you forget your keys, or whatever, you will have to disarm your alarm. Or remove the Exit Zone and just have the countdown timer.
I think it would be possible to get the keys if you have a motion sensor as cross zone sensor? I have a motion sensor that does not cover the first two meters inside my house (after I enter the door, triggering the door sensor). So the alarm should (in theory) not go of until I enter the cross zone, I think. I haven't tried this actually...
I think it would be possible to get the keys if you have a motion sensor as cross zone sensor? I have a motion sensor that does not cover the first two meters inside my house (after I enter the door, triggering the door sensor). So the alarm should (in theory) not go of until I enter the cross zone, I think. I haven't tried this actually...
Replies have been locked on this page!