MICROMODULE SWITCH DOUBLE S1/S2 in charge

Manuel Rocha shared this problem ago

Known

I've bought 3 MICROMODULESWITCH DOUBLE...

All of then the S1/S2 have 220v voltage... Is this normal?

According to diagram the voltage should come from switch and not backwards...

The same problem 0

Replies (1)

Sawadee ●

I have the same issue except using at 115VAC and that is what I measure on these two lines with nothing connected.

Reply URL

Manuel Rocha ●

Hi there,

It seems that this is a normal behavior from zipato micro module. My issue was that I could not switch on/off the lights from the buttons, only within the app. This is because my house was three-phase and all the circuit should be on same phase (which on my case wasn't).

Is your home single-phase or three-phase?

Kind Regards,

Manuel Rocha

URL

Sawadee ●

My home (USA) has 115VAC split phase. 230VAC with a center tap. So two phases of 115AC. Commonly called single phase.

My real issue is that I can not control the on and off state of this device using the S1 and S2 lines. I can control it with the button on the device and when included in the Z-Wave network. But applying 115VAC to S1 and or S2 with a switch just does nothing. I assume there is a setting that I need change but don't know what to change.

URL

Manuel Rocha ●

I'm not home now, but when I get there I will make a diagram on how you should connect the wires correctly on that case.

URL