No endpoints when adding Somfy RTS Centralis box to Zipabox

Willem Hoeve shared this question ago

Answered

To make my sunscreen remote controlled I added a Somfy Centralis RTS box. My sunscreen has a conventional (non RTS) motor. By adding the Somfy Centralis RTS box I can add it to the Zipabox. It is recognized by the Zipabox but there are no endpoints detected. I think the reason for this is that the sunscreen has mechanical endpoints.

Because of this I cannot control the sunscreen with the Zipabox. Is there a way to solve this? Is it possible to add virtual endpoints so that I can control the screen? (the screen will stop automatically because of the mechanical endpoints). I can control the screen with a somfy remote control (telis 4).

Any help or ideas would be appreciated.

Thanks in advance.

The same question

Best Answer

Željko Cerovski ●

First of all, if you did not, you should upgrade to the latest beta release of zipabox firmware.

Then try to re-add your device.

Replies (2)

Željko Cerovski ● ●

First of all, if you did not, you should upgrade to the latest beta release of zipabox firmware.

Then try to re-add your device.

Reply URL

Willem Hoeve ●

Dear Zeljko,

Upgrading the box to the latest beta release did the trick! After re-adding the Somfy Centralis RTS device I was able to configure the settings. Everything is working fine now.

Thanks for your swift reply.

Kind regards,

Willem Hoeve

Zaandijk

The Netherlands

Reply URL