Somfy support !

Guilhem Nicolas shared this question ago

Answered

Hello,

Do you have a method for programming the roller SOMFY ?

Doesn't work for me...

Thank you

Nicolas

The same question

Replies (3)

Guilhem Nicolas ●

Sorry but the shutter doesn't work...

I do your method with somfy remote already programming !

Reply URL

Guilhem Nicolas ●

Ok mail send !

thx you Ivan

Reply URL

Guilhem Nicolas ●

Ivan wrote:

Hi,

First you have to programm A Somfy Remote (here is a link how to do it):

https://www.youtube.com/watch?v=rRqjmLTtWKM

If you need to reset your Somfy motor prior to any programming, then use these instructions:

https://www.youtube.com/watch?v=kP-AziUgJ1s

Inclusion with Zipabox (433Mhz protocol):

- start the procedure for adding new device;

- before clicking on continue you have to set the device in learning mode by pressing and holding reset button on the backside of remote controller until the roller shutter jogs;

- press continue and the device will join.

Configuring the time for shutters going down and up, and configuring bottom and top offset is done via endpoint configuration (Total devices in Control Center > go to Somfy + right click). This is done as follows:

- you need to count seconds/time until the shutters go down (100%) and up (100%), they are usually the same, but all depends on the weight of the shutters and motor strength;

- top and bottom offset are important and they are usually 25% of the value in seconds of fully closed (bottom) or open shutters (top).

Regards,

Ivan

First you have to programm A Somfy Remote (here is a link how to do it):

https://www.youtube.com/watch?v=rRqjmLTtWKM

If you need to reset your Somfy motor prior to any programming, then use these instructions:

https://www.youtube.com/watch?v=kP-AziUgJ1s

this is not necessary if one already has a programed TLCD ?

thanks for your help !

Reply URL