zipato micromodule motor controller ph-pan08.us Need parameters!
Solved
I only can make the shutters go up or down. I cant make them stop in a %. Seems i Need manual parámeters and valúes to set it up. There in no manual or tutoríal how to do it. I read that if i open and close full cycle three times it will configure automáticly. But dont. Need help with this
The same problem 
No connection
Real-time notifications may not work
Solved. I sent an email to Zipato and they answer very quickly. They sent me the manual. before join the device i must push join button for 3 segs. and start the calibration. Then I joint it and everithing its ok.
Thanks Zipato
Solved. I sent an email to Zipato and they answer very quickly. They sent me the manual. before join the device i must push join button for 3 segs. and start the calibration. Then I joint it and everithing its ok.
Thanks Zipato
Thank you for sharing this solution with everyone else who might be experiencing the same problem.
Best regards,
Hrvoje
Thank you for sharing this solution with everyone else who might be experiencing the same problem.
Best regards,
Hrvoje
Replies have been locked on this page!