Zwave.me Keyfob button 3 and 4 not working
Solved
hello,
I have included successfully my keyfob.
I have created rules to run scene when button are clicked.
Scene are run when button 1 or 2 is clicked but not when button 3 or 4 is clicked.
Can you help me please?
The same problem 
No connection
Real-time notifications may not work
Hello,
So I have solved my problem without the help of anyone from Zipato (again).
I'll post the answer here guessing that it will help a someone, someday.
After configuring the rules in zipato and synchronizing it, you have to enter in management mode in the keyfob and then press button 2.
Hello,
So I have solved my problem without the help of anyone from Zipato (again).
I'll post the answer here guessing that it will help a someone, someday.
After configuring the rules in zipato and synchronizing it, you have to enter in management mode in the keyfob and then press button 2.
Thank you Nicolas i had the same problem last week.
I will try your solution but i can't add or remove any device since yesterday. Count down never begin to reset or add.
Thank you Nicolas i had the same problem last week.
I will try your solution but i can't add or remove any device since yesterday. Count down never begin to reset or add.
Hi hatipoglu79@hotmail.com
please contact us on support@zipato.com
and we will check the status of your Zipabox
Kind regards,
Hrvoje
Hi hatipoglu79@hotmail.com
please contact us on support@zipato.com
and we will check the status of your Zipabox
Kind regards,
Hrvoje
Replies have been locked on this page!