This object is in archive! 

All my Z-Wave devices are not responding normally

Slashroot shared this problem 9 years ago
Known

Hi,


After the firmware update all my z-wave device do not respond directly. It takes several 5+ minutes before device responses to an action and my rules are also not working.


Funny part is that i can control RF433 devices


Anyone else has this issue?


(Yes i synchronised, restarted several times etc)

Replies (4)

photo
1

My rules stopped working 4 days ago.

I had made no modification of settings or rules but after switching off every rule one by one I have found the one which was causing trouble.

Now that it is deactivated everything runs flawlessly.

Did you try to switch off every rules one by one?

photo
1

My rules are not the problem. All Z-wave devices reported back to the Zipabox (sensors/meters). All RF433 devices were working properly.

Rules were executed only it took 5+ minutes before each device (lamps) would receive the action. I could even see in the live event viewer that all meters and sensors were reporting and now and then a item would be in this view with an old execution time, like sensor reported X at 19:03, light turned at 18:53, meter reported 19:04


I rolled back to the old firmware and all is good now

photo
1

Did you contact supported about this?


Looks like a devices it yamming your signal.

photo
1

I had created a support ticket and provided them with a big list of entries where i explained research.

If a device would be jamming the 2i firmware would have this issue also.


Zipato did not have an answer and advised me to stay on 2i firmware for now

Leave a Comment
 
Attach a file