This object is in archive! 
TZ68 - Parameter 1 not possible to set?
Need Answer
I am trying to configure my TZ68 wall switch using the parameters available here:
http://www.pepper1.net/zwavedb/device/322
Parameter 1 = 0 will turn off the LED.
When I am trying to set the parameter, selecting parameter 1 induces "spelling error" shown in image:
Also, there is a option to select "Night Mode", but that seems to not give any result(?)
Anyone that can intepret the term "Night Mode"? Myself, I can see two possible answers:
1 Night mode is = LED off, what I am trying to acheive.
2 Night mode is an illumination by the LED to be used for example in children bedroom.
You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
No connection
Real-time notifications may not work
I submitted a support case on this and the techs added the option to turn off the LED.
It was done both for the on/off switch TZ68 as well as the dimmer TZ67.
Had to remove/add the device to get the option.
Unfortunately, it didn't work for me. Anyone else that can test this?
I submitted a support case on this and the techs added the option to turn off the LED.
It was done both for the on/off switch TZ68 as well as the dimmer TZ67.
Had to remove/add the device to get the option.
Unfortunately, it didn't work for me. Anyone else that can test this?
Replies have been locked on this page!