This object is in archive!
TZ68 - Parameter 1 not possible to set?
Need Answer
I am trying to configure my TZ68 wall switch using the parameters available here:
http://www.pepper1.net/zwavedb/device/322
Parameter 1 = 0 will turn off the LED.
When I am trying to set the parameter, selecting parameter 1 induces "spelling error" shown in image:
Also, there is a option to select "Night Mode", but that seems to not give any result(?)
Anyone that can intepret the term "Night Mode"? Myself, I can see two possible answers:
1 Night mode is = LED off, what I am trying to acheive.
2 Night mode is an illumination by the LED to be used for example in children bedroom.
The same question
No connection
Real-time notifications may not work
I submitted a support case on this and the techs added the option to turn off the LED.
It was done both for the on/off switch TZ68 as well as the dimmer TZ67.
Had to remove/add the device to get the option.
Unfortunately, it didn't work for me. Anyone else that can test this?
I submitted a support case on this and the techs added the option to turn off the LED.
It was done both for the on/off switch TZ68 as well as the dimmer TZ67.
Had to remove/add the device to get the option.
Unfortunately, it didn't work for me. Anyone else that can test this?
Replies have been locked on this page!