Toggle is not working between zwave and Chacon (422mhz) module.
Solved
Hello,
Il I create a rule : if chacon button (WBT-912) is toggle then toggle this Fibaro power switch (2x1.5Kw).
Nothing happens when I press on the button.
If I ask the light to toggle when the switch is on, it is workink but I need to press 4 times to toggle.
I need to use 3 switchs to pilot one light, what is the best solution?
Thanks for your help.
The same problem 
No connection
Real-time notifications may not work
Try replacing the battery in the module.
Also try moving it out of the wall.
If you need to press 4 times, the signal is to weak for some reason.
Also check your switch and wires, a loose connection may also cause this.
Try replacing the battery in the module.
Also try moving it out of the wall.
If you need to press 4 times, the signal is to weak for some reason.
Also check your switch and wires, a loose connection may also cause this.
Thanks for your answer!
I'll try this this week-end.
Thanks for your answer!
I'll try this this week-end.
Replies have been locked on this page!