New Topic
Zipato support centerTopicQuestionUncategorized
This object is in archive! 
Properties
Category Uncategorized
Tags stellaz, device wizard;

Adding a EUR_Stellaz thermostat into my network

Alistair Burn shared this question 11 years ago
Need Answer

When I try to add a EUR_Stellaz thermostat into my network, what do I select in the 'add new device wizard' because this device isn't listed? Thanks

1 The same question

Replies (3)

photo
1
Marko Katić ● 11 years ago

Any Z-wave device can be added by selecting the "Generic Z-wave" from the drop down menu in the "Add new device wizard".

Reply
photo
1
Ray Glendenning ● 11 years ago

My previous posts are not showing up for some reason!


Anyway, please can you report back if the Stella Z actually works now?

Reply
photo
1
Theo van den Dolder ● 11 years ago

Ray Glendenning wrote:

My previous posts are not showing up for some reason!


Anyway, please can you report back if the Stella Z actually works now?

I have 3 StellaZ's in my living room/kitchen and they work fine.

  • I made a virtual switch, the virtual switch is the (only) output for the climate widget
  • I made a rule Heating > when virtual switch is on then set al valves to THERMOSTAT_MODE value HEAT
  • I made a rule Not Heating > when virtual switch is off then set al valves to THERMOSTAT_MODE value OFF

more information and the rules see my last post in this tread:http://community.zipato.com/responses/eurotronic-stellaz

Reply
Leave a Comment
 
Attach a file
Powered by: UseResponse - Ideas Management Software
You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!