Adding a EUR_Stellaz thermostat into my network

Alistair Burn shared this question ago

Need Answer

When I try to add a EUR_Stellaz thermostat into my network, what do I select in the 'add new device wizard' because this device isn't listed? Thanks

Replies (3)

Marko Katić ●

Any Z-wave device can be added by selecting the "Generic Z-wave" from the drop down menu in the "Add new device wizard".

Reply URL

Ray Glendenning ●

My previous posts are not showing up for some reason!

Anyway, please can you report back if the Stella Z actually works now?

Reply URL

Theo van den Dolder ●

My previous posts are not showing up for some reason!

Anyway, please can you report back if the Stella Z actually works now?

I have 3 StellaZ's in my living room/kitchen and they work fine.

I made a virtual switch, the virtual switch is the (only) output for the climate widget
I made a rule Heating > when virtual switch is on then set al valves to THERMOSTAT_MODE value HEAT
I made a rule Not Heating > when virtual switch is off then set al valves to THERMOSTAT_MODE value OFF

more information and the rules see my last post in this tread:http://community.zipato.com/responses/eurotronic-stellaz

Reply URL