Problem to address Remotec ZRC-90 Buttons

Roman Pichler shared this problem ago

Known

HalloI have bought a ZRC-90. The inclusion process was successfully and the device manger recognizes it as ZRC-90. However, when i create a rule and want to address one of the button it does not work. I am not able to choose among button 1-8. Instead i only can choose among the options: sensor state true or sensor state false.

What I am doing wrong?

Do someone have an advice?

Thanks

The same problem 0

Replies (5)

Adrian Van Der Heijden ●

the buttons should be located under the "control" menu in the rule creator, did you check there?

Reply URL

Sake Miedema ●

Adrian,

Thanks for your reply. I'm having the same problem. I can't find the buttons located under the "control" menu. The ZRC-90 is located under the "activator" menu and shows as seen in the attached file.

Files:

URL

Robert K ●

Did you figure this out? I am having the same issue

Reply URL

Xavier Rodríguez ●

Same issue, any update?

Reply URL

Guest ●

I had the same issue but after installing the Beta Firmware it works :-)

a1706b3032b695cfc6a53a6437ca8bf2

Reply URL

Maria Schulz ●

Are there any news regarding this problem? At my interface it still looks like on Sake Miedemas picture.

Reply URL

Sake Miedema ●

Maria, if you follow the comment of Alexander, you will succeed. If you use the Beta firmware first and install the remotec (-s) you can go back to the original firmware afterwards. Good luck!

URL