This object is in archive!
Clearing accumulated power consumption Everspring AN158
Need Answer
Hello,
In the manual of the EVERSPRING AN158 (On/Off module withe mesure of consumption), fully supported by the zipabox, to clear the accumulated power consumption I'll have to send :
Meter Reset Command: [Command Class Meter, Meter Reset]
How could I clear the value or send the meter reset command to the device ?
Thanks for your answer.
Fred
The same question
No connection
Real-time notifications may not work
Ok found.
Go to the device manager and reinitialized the device.
Ok found.
Go to the device manager and reinitialized the device.
Hi,
Can you give me the steps to follow?
I can not find how to reset these device :-(
Thanks.
Hi,
Can you give me the steps to follow?
I can not find how to reset these device :-(
Thanks.
Currently, Is is not possible to send a meter reset command from the dashboard.
However, a factory reset procedure is documented on the first page of the manual, have you tried doing that?
Currently, Is is not possible to send a meter reset command from the dashboard.
However, a factory reset procedure is documented on the first page of the manual, have you tried doing that?
Hi,
In device manager, if i use "Re-apply device descriptors" button, the accumulated power consumption is cleared.
Thanks.
Hi,
In device manager, if i use "Re-apply device descriptors" button, the accumulated power consumption is cleared.
Thanks.
"Re-apply device descriptors" didn't work :(
is there other way? Does anybody know?
"Re-apply device descriptors" didn't work :(
is there other way? Does anybody know?
Replies have been locked on this page!