This object is in archive! 

FGD 211, parameter modification

Yann Roland shared this problem 10 years ago
Not a Problem

Not sure the parameter modification with the zipabox works.

if i associate the module to my ZRC-100 remote and make the parameter modification, everything is fine.

If i associate the module to the zypabox and make the parameter modification, the switch seems to be always in monostable mode

Replies (4)

photo
1

When you make the changes to the parameter do you 'save' and then 'synchronise'?


Sometimes the changes do not take effect unless you sync.


Then wait for a minute for the device to update.

photo
1

Mark Onions wrote:

When you make the changes to the parameter do you 'save' and then 'synchronise'?


Sometimes the changes do not take effect unless you sync.


Then wait for a minute for the device to update.

photo
1

I have saved the parameter but not sure for the synchronisation. Where is the button to synchronise ?

photo
1

Ok that was only that. Everything is fine now !

Leave a Comment
 
Attach a file