Fibaro RGBW - Questions/Bugs

First off >> Great that we can change colours! Now i can finally play.

Q01:

I got a RGBW ledstrip. When i change the colour to full red (0/0/255) the led puts the white led on (can't select the white on). So there is no full red (but mixed). Is there away to turn off the white led?

Q02:

What parameters to use when u have a normal light switch (BI-stable) on the controller?

Bug 01:

I have a fav colour Red (0/0/255) when i click on the circle (blue part) it changes then when a click again on the fav red colour it is not showing the right colour and position. I have to click again on the fav. red to get the right colour.

Bug 02:

Slider don't show right position when u click in the circle.

Wish 01:

Can u make the circle a bit bigger because often i click in the square and not on the circle? Happens often with blue.

Bug 03:

When u click in the circle the bars and colour changes. Then when u change the numbers the colour doesn't change when enter the seconds number.

Bug 04:

In the Android app the rgbw lights are not shown in lights and power but when i go to rooms they are there.

Do you experience this problems all the time or is it just sporadic?

Hi Nenad,

Fast reply! Thanks

The wit is working now. Great! Now i can make real red :)

Also i tried to reproduces the above bugs and all are solved maybe the white was causing the problems?

Only the Andriod bug (04) remains.

Bug 05:

When i add a fav. colour the white colour position is not saved.

So when a leave the panel and turn it off and then on (white is full) then run a rule that turns the light on fav. colour Red (#ff0000) it mixes with the white. So there is no full red.

Rule:

I think that when i use the RGB in the rule creator u should only use the RGB leds when u use the RGBW in rule it should use the RGB and White colour.

Also this problem is in the colour pop in the dashboard.

(windows 7 (64bit) NL - Firefox 22)

Can u please answer this question:

What parameters to use when u have a normal light switch (BI-stable) on the controller?

Because it's not working. Switchting on works fine but off is not working (i have to switch on/off several times).

I put all 4 wires from the input into 1 wire on the switch.

Answer for Question:

Set parameter 14 to 21845 (all inputs set to TOGGLE (BRIGHTNESS MODE)) to work with bi-stable

Thanks zipato!

Bug 05 >> is also fixed! Great!