This object is in archive!
Power Module
Known
I have now the power module connected to my box.The
power module is recognized. I have 1 clamp connected. When starting the
box, it only reads the 4 power module port once, with all values zero
(there should be some value on the camp port) and never again.
The same problem 
No connection
Real-time notifications may not work
Did you disconnected the power from the zipabox? And connect the power to the power module (without a adapter)?
Did you disconnected the power from the zipabox? And connect the power to the power module (without a adapter)?
yep did that.
yep did that.
Hmm, than i don't know.
I also had problems with this devices. You better contact support about this support@zipato.com or support.zipato.com.
Please report back the solution.
Hmm, than i don't know.
I also had problems with this devices. You better contact support about this support@zipato.com or support.zipato.com.
Please report back the solution.
Alright I will do that. Thanks for your advice.
Alright I will do that. Thanks for your advice.
I have a zipabox 2 and a amper meter clamp conected to a power expansion module on channel one. The problem that I have is that the measures are innacurate, it even gives negative measures or equal to zero, like the devices were not working.
Could you please help me to resolve this issue?
I have a zipabox 2 and a amper meter clamp conected to a power expansion module on channel one. The problem that I have is that the measures are innacurate, it even gives negative measures or equal to zero, like the devices were not working.
Could you please help me to resolve this issue?
Replies have been locked on this page!